Hydromech Hoist Drive Brake Parts: ZFB40–ZFB150 Compatibility

Check Hydromech hoist drive brake parts for ZFB40 to ZFB150 fit by hoist type, voltage and SA part number before you order.

A mismatched brake component can hold up a hoist repair and add work at reassembly. Our Hydromech hoist drive brake parts listing covers ZFB40, ZFB60, ZFB100 and ZFB150 brakes, but compatibility depends on more than the ZFB number. Before ordering, match the hoist type, brake model, operating voltage and Hydromech SA part number.

Which Hydromech Hoist Drive Brake Parts Fit Each Hoist Type?

Our listing maps ZFB40 parts to MDA and CA hoists, and ZFB60 parts to MFA and DB hoists. ZFB100 parts are listed for MHA, MGA, DC and DD hoists, while ZFB150 parts are listed for MJA and DD hoists. Treat this map as a starting point, not proof of fit.

DD appears under both ZFB100 and ZFB150, so ordering from the hoist code alone is risky. Brake size, coil voltage and existing part details still need checking. The drive brake parts listing shows descriptions and SA part numbers for each range. It also lists brake parts for EFB2 and EFB3 travel motors, so confirm you are looking at a hoist drive brake and not a travel motor brake.

Details to Confirm Before Ordering

Check the identification plate and existing brake components before you remove labels, wiring or worn parts. Note the following:

• Hoist type: Record the full designation, such as MDA, MFA, MHA, MGA, MJA, CA, DB, DC or DD.
• Brake model: Confirm whether the installed brake is marked ZFB40, ZFB60, ZFB100 or ZFB150.
• Operating voltage: The listing includes 195V, 98V and 64V options, so note the voltage and supply of the existing coil or assembly.
• Required component: Identify whether you need a complete assembly, coil, brake disc, armature plate, springs or another listed item.
• Part number: Provide the existing SA number so we can compare it with the published range.

Complete Assembly or Individual Parts?

A complete assembly from our Hydromech hoist drive brake parts range may suit a brake with wear or damage across several parts, or when individual items cannot be identified with confidence. Coils, brake discs, armature plates and springs are also listed separately. Springs are normally listed by the set, with six per set shown for ZFB40 and ZFB60 and seven for ZFB100, so confirm quantities before you order.

The listing also notes rectifier changes for older units, including G30, B40, SE40 and PMG400. These are not automatic approval for a swap, because the electrical set-up can differ between hoists.

Safe Work Australia’s guide to inspecting and maintaining cranes says replacement parts should meet the original part’s specification, and it lists brakes among the critical parts for visual inspection and measurement. Follow the equipment instructions for installation, adjustment and testing, and have a competent person carry out the work.

Order Matched Hoist Brake Parts in Australia

We supply listed components and complete assemblies across the ZFB40 to ZFB150 range. Clear equipment details let us check Hydromech hoist drive brake parts against the current listing without guessing at fitment.

Send your hoist type, brake marking, voltage and existing part number through our contact page, with clear photos of the identification details if you can. We can then help narrow the listed options before you order.

Optimized by: Netwizard SEO